Names of arrow guides
- Bede
- Posts: 2360
- Joined: Mon Mar 14, 2005 11:57 am
- Location: Sydney, Australia
Names of arrow guides
Navak means guide in Farsi (Persian) and Majra means guide in Arabic. These words normally describe the same class of equipment.
In its simplest form, the majra or navak is a long stick with a groove down one side deep enough for at least half the diameter of the arrow to fit into it. Usually the groove is deeper than that and the length of the stick is slightly longer than a full-length arrow. There is some sort of string at one end to secure the guide to the drawing hand. It may have a ring to go over the little finger or a loop or ar simple button. It was used from Egypt to Korea.
A more complex form is hollow with a slot in the top and one in the bottom. These openings do not run the full length of the guide, but only far enough for the bow string to complete its stroke. Usually the top slot is wider than the bottom to allow the arrows to be dropped in. Some of the guides in this class have a horn runner and can shoot pellets.
The word navak is used in another context in Farsi. The navak-i-qabza or grip guide is a wholly different thing. It was usually made of metal and tied to the grip of the bow. It was a groove with a tab on one side near the front end. This tab was tied to the bow. An arrow was draw down the groove several inches inside the bow. This allow you to use shorter arrows, but not so short as the usual navak.
The siper or bilek siperi (wrist shield) is what the Ottoman Turks used. It was a groove, oluk, mounted on a shaped wooden block, eshik, glued to a strap and harness, tasma, which tied it to the wrist. Often it had an oval plate, tabla, with a cut out at the front so it could be slid into slots in the eshik.
There is another type of siper which had only a flat plate of horn or tortoiseshell with two raised ridges to stop the point of the arrow from moving to either side.
There is also a ring, whose name I do not know, which had a small shield to protect the thumb from the arrow point.
For Turkish readers, I am sorry, but I haven't found out how to write all the Turkish consonants on this forum.
In its simplest form, the majra or navak is a long stick with a groove down one side deep enough for at least half the diameter of the arrow to fit into it. Usually the groove is deeper than that and the length of the stick is slightly longer than a full-length arrow. There is some sort of string at one end to secure the guide to the drawing hand. It may have a ring to go over the little finger or a loop or ar simple button. It was used from Egypt to Korea.
A more complex form is hollow with a slot in the top and one in the bottom. These openings do not run the full length of the guide, but only far enough for the bow string to complete its stroke. Usually the top slot is wider than the bottom to allow the arrows to be dropped in. Some of the guides in this class have a horn runner and can shoot pellets.
The word navak is used in another context in Farsi. The navak-i-qabza or grip guide is a wholly different thing. It was usually made of metal and tied to the grip of the bow. It was a groove with a tab on one side near the front end. This tab was tied to the bow. An arrow was draw down the groove several inches inside the bow. This allow you to use shorter arrows, but not so short as the usual navak.
The siper or bilek siperi (wrist shield) is what the Ottoman Turks used. It was a groove, oluk, mounted on a shaped wooden block, eshik, glued to a strap and harness, tasma, which tied it to the wrist. Often it had an oval plate, tabla, with a cut out at the front so it could be slid into slots in the eshik.
There is another type of siper which had only a flat plate of horn or tortoiseshell with two raised ridges to stop the point of the arrow from moving to either side.
There is also a ring, whose name I do not know, which had a small shield to protect the thumb from the arrow point.
For Turkish readers, I am sorry, but I haven't found out how to write all the Turkish consonants on this forum.
Bede
- Thomas Duvernay
- Posts: 440
- Joined: Sat Mar 12, 2005 11:37 pm
- Location: hometown: Michigan, USA/current location: South Korea
- Contact:
- Bede
- Posts: 2360
- Joined: Mon Mar 14, 2005 11:57 am
- Location: Sydney, Australia
- Thomas Duvernay
- Posts: 440
- Joined: Sat Mar 12, 2005 11:37 pm
- Location: hometown: Michigan, USA/current location: South Korea
- Contact:
Bede,
They are modern, made by Korean fletcher Yoo Young-gi. I should have mentioned I hot-linked the picture from his website:
http://www.arrow.or.kr
I have not heard of Korean pyonjon as ever having been heavy; their main purpose was getting distance and hitting the enemy before they got within standard arrow range. It was one reason for the discontinuation of the tong-ah/pyonjon; they lost their effectiveness when enemy armor was improved, and penetration decreased.
T
They are modern, made by Korean fletcher Yoo Young-gi. I should have mentioned I hot-linked the picture from his website:
http://www.arrow.or.kr
I have not heard of Korean pyonjon as ever having been heavy; their main purpose was getting distance and hitting the enemy before they got within standard arrow range. It was one reason for the discontinuation of the tong-ah/pyonjon; they lost their effectiveness when enemy armor was improved, and penetration decreased.
T
- Bede
- Posts: 2360
- Joined: Mon Mar 14, 2005 11:57 am
- Location: Sydney, Australia
Thomas,
That is very interesting. Those points looked heay to me, but a photograph can be misleading. Of course, by "heavy" I do not mean heavier than an ordinary long arrow with the same tip.
In Arabic and Persian literature, armour piercing darts were recommended for their effectiveness against helmets and shields. I haven't anything setup to test penetration, but eventually I will get round to it. Darts were normally considered to have greater range and velocity than a standard long arrow.
I have seen an article in the Glade magazine by Mark Stretton on the effectiveness of traditonal English arrow heads on armour and flesh when shot from an English longbow af great power. I believe there might be a cable TV show about it too, though I have not seen it. The article was impressive and left me in no doubt that one should have the maximum distance possible between you and an English archer if you wanted to survive the experience. How much farther you would have to stand to escape a Korean archer!
That is very interesting. Those points looked heay to me, but a photograph can be misleading. Of course, by "heavy" I do not mean heavier than an ordinary long arrow with the same tip.
In Arabic and Persian literature, armour piercing darts were recommended for their effectiveness against helmets and shields. I haven't anything setup to test penetration, but eventually I will get round to it. Darts were normally considered to have greater range and velocity than a standard long arrow.
I have seen an article in the Glade magazine by Mark Stretton on the effectiveness of traditonal English arrow heads on armour and flesh when shot from an English longbow af great power. I believe there might be a cable TV show about it too, though I have not seen it. The article was impressive and left me in no doubt that one should have the maximum distance possible between you and an English archer if you wanted to survive the experience. How much farther you would have to stand to escape a Korean archer!
Bede
- Bede
- Posts: 2360
- Joined: Mon Mar 14, 2005 11:57 am
- Location: Sydney, Australia
Korean Arrowmaker
Thomas,
This is a separate question. How does the arrow rack in http://www.arrow.or.kr/frame6.htm work? How do you take the arrows out when they have such big heads?
I make arrow racks for arrows in construction and for storage, but I haven't a good design for broadheads. My two designs have either a removeable piece on the section with the holes or a long slot that runs through the holes.
This is a separate question. How does the arrow rack in http://www.arrow.or.kr/frame6.htm work? How do you take the arrows out when they have such big heads?
I make arrow racks for arrows in construction and for storage, but I haven't a good design for broadheads. My two designs have either a removeable piece on the section with the holes or a long slot that runs through the holes.
Bede
- Thomas Duvernay
- Posts: 440
- Joined: Sat Mar 12, 2005 11:37 pm
- Location: hometown: Michigan, USA/current location: South Korea
- Contact:
For some strange reason, that frame is not appearing on my computer now. Still, I can imagine what you are referring to. I think the rack was made especially for the arrows by Master Yoo, and only for show, so there was not really a need for them to easily be put in and taken out, but that is only a guess. Sometime, when I visit his museum again, I'll be sure to look.
T
T
-
Diana
- Posts: 21
- Joined: Sat Mar 12, 2005 7:48 pm
- Location: Dallas, Texas, USA
- Thomas Duvernay
- Posts: 440
- Joined: Sat Mar 12, 2005 11:37 pm
- Location: hometown: Michigan, USA/current location: South Korea
- Contact:
-
Diana
- Posts: 21
- Joined: Sat Mar 12, 2005 7:48 pm
- Location: Dallas, Texas, USA
- Thomas Duvernay
- Posts: 440
- Joined: Sat Mar 12, 2005 11:37 pm
- Location: hometown: Michigan, USA/current location: South Korea
- Contact:
- Gianrico
- Posts: 86
- Joined: Mon May 09, 2005 8:18 pm
- Location: Geneva, Switzerland
Arrow guide
Hello,
I like the concept of arrow guide with short arrows, but I don't understand how it works effectively. There isn't a graphic or so (the best would be a movie
) which explain?
Thanks, best regards
Gianrico
I like the concept of arrow guide with short arrows, but I don't understand how it works effectively. There isn't a graphic or so (the best would be a movie
Thanks, best regards
Gianrico
- Thomas Duvernay
- Posts: 440
- Joined: Sat Mar 12, 2005 11:37 pm
- Location: hometown: Michigan, USA/current location: South Korea
- Contact:
I'll see if I can find a video somewhere. In the meantime, have a look at these pages (in Korean, but lots of pics):
http://archery.news-paper.co.kr/news_vi ... id=&ss_id=
http://archery.news-paper.co.kr/news_vi ... id=&ss_id=
http://archery.news-paper.co.kr/news_vi ... id=&ss_id=
http://archery.news-paper.co.kr/news_vi ... id=&ss_id=
http://archery.news-paper.co.kr/news_vi ... id=&ss_id=
http://archery.news-paper.co.kr/news_vi ... id=&ss_id=
http://archery.news-paper.co.kr/news_vi ... id=&ss_id=
http://archery.news-paper.co.kr/news_vi ... id=&ss_id=
- Gianrico
- Posts: 86
- Joined: Mon May 09, 2005 8:18 pm
- Location: Geneva, Switzerland
- Thomas Duvernay
- Posts: 440
- Joined: Sat Mar 12, 2005 11:37 pm
- Location: hometown: Michigan, USA/current location: South Korea
- Contact:
















